So follow the owners manual, and if youve lost it already, request an additional copy of the same from the business. And to identify the fault better and much faster, choose to repair your air conditioner on a day that is relatively warm.
Be sane while you repair it. Cut off the power flow to the unit while you are at it. The a/c unit normally has a switch off panel for this. But, just in case you do not find any such panel, cut off the electricity to the entire house for that time. Also, rake away all debris from the condenser outside while you begin the cleaning task.
The initial step to identifying where the fault is is to take the grill cover off the condenser. Then, clean the blades or fins with a soft brush or some soft material, making sure to see that you do not harm the fragile fins in any way. After cleaning these, you need to dry them. Next, remove the screws and remove the grill-cover extremely carefully, since the fans stay attached to them, and you could unintentionally pull loose some wires. Then you need to hose out the fins, keeping the motor covered with some water resistant material.
Since you have already dismantled your air conditioner so much, you might as well lube the motor a little in this circumstance. Finally, put back all the parts in their right spots, and you are done with a short and easy air conditioner repairing effort For more Information .
Now, to see if youve actually set all of it right, turn the power on and let the machine run for some time. Put your hands on the two pipes connected to the condenser. If one is warm and the other is cool, your unit is all right. But, if it isnt so, possibly you need to recharge the refrigerant. And this cant be done alone. So call a professional.
If your a/c unit does not turn on automatically, you could check out the following steps. First, guarantee that the thermostat is set to cool, and is below the room temperature. Second, a blown-out fuse could also be the reason as much as a tripped breaker on the main panel. Third, keep the power switch on the furnace and the condenser switch on the outside switched on. Fourth, but not least, guarantee that the 240-volt disconnect is not switched off. It is placed just next to the outside compressor.